 |
Back |
For full Warranty details please refer to the product profile!
Electronic Packaging Material - Potting and Encapsulating Gels
Details: EPM-2482 - Extreme Temperatures
| Product Profile: | EPM-2482P.pdf |
|---|---|
| MSDS PDF A: | EPM2482A.pdf |
| MSDS PDF B: | EPM2482B.pdf |
Basic Product Overview: |
|
| Section: | Electronic Packaging Material |
| Description: | Potting and Encapsulating Gels |
| NuSil ID: | EPM-2482 |
| Viscosity A: | |
| Viscosity B: | |
| Viscosity Mixed: | |
| Flow/Viscosity: | 2,000 (mixed) |
| Cure System: | Platinum Addition |
| Solids Content: | - - |
| Work Time: | 1 D |
| Cure Time/Temp: | 40 m / 150 |
| Post Cure Time/Temp: | - - |
| Specific Gravity: | - - |
| Durometer Type A Certified: | - - |
| Durometer Type A Typical: | Firm Gel |
| Tensile psi Certified: | - - |
| Tensile psi Typical: | - - |
| Tensile MPa Certified: | - - |
| Tensile MPa Typical: | - - |
| Elongation Percent Certified: | - - |
| Elongation Percent Typical: | - - |
| Tear PPI Certified: | - - |
| Tear PPI Typical: | - - |
| Tear kN/m Certified: | - - |
| Tear kN/m Typical: | - - |
| Ionic Content* CI - K / Na ppm | <5 / <1 / <4 |
| Lap Shear psi/Mpa: | - - |
| Volume Resistivity** ohm·cm | 1 x 1014 |
| Dielectric Strength V/mil: | - - |
| Operating Temp: | -115 to 2560 |
| Plasticity/Viscosity/Extrusion Typical: | - - |
| Stress Strain: | - - |
| Mix Ratio: | 1:1 |
| Colour: | Trans |
| Comments: | Extreme Temperatures |
|
Back | Please note: Alternative sizes and packaging can and may be supplied, subject to availability of stock. Products pictured may vary and illustrations are for guidance only! |
|
